금속통 생산 및 스프레이 공정
Metal Pails 생산 및 스프레이 공정
Metal Pails are usually sprayed by high-pressure airless spraying and air spraying. Air spraying has strong adaptability and high efficiency. The main disadvantage is that the paint loss is large and the environmental pollution is large. It is best to use mechanical spraying for shaping Metal Pails products, and high-pressure airless spraying is the most ideal." (Closed paint iron drum) The coating application process has certain particularities, which are mainly controlled from three aspects. Surface treatment, spraying .Baking etc.
1: 금속통 표면 탈지
Use special surface degreaser for steel plates. When degreasing, immerse the barrel body, barrel bottom, and barrel cover in the degreasing tank. After soaking for 5 minutes, use special cleaning equipment or brushes to brush the surface to be sprayed on the workpiece to promote the chemical treatment of oil stains. reaction. The higher the temperature of the degreasing bath, the faster the degreasing speed and the more thorough the degreasing. The temperature will change the physical properties of the grease. As the temperature of the degreasing bath increases, the viscosity decreases accordingly, which is convenient for the formation of droplets and removal. (Closed galvanized bucket) The temperature of the degreasing bath is increased by 10 C. The chemical reaction rate can be doubled." Immerse the degreasing workpiece in a clean water bath, and use a brush to wash the residual liquid or residue. There should be no grease on the surface of the workpiece after cleaning. There should be no water droplets on the naked eye. No greasy touch:
세척된 공작물은 공정 요구 사항에 따라 즉시 표면 인산염 처리를 위해 인산염 처리 탱크에 담가야 합니다. 표면 인산염 처리를 즉시 수행할 수 없는 경우 공작물의 표면을 즉시 건조해야 합니다. 또는 깨끗한 천으로 닦아서 녹슬지 않도록 하십시오. 체류 시간은 2시간을 초과하지 않아야 하며 물에 노출되어서는 안 됩니다. 게다가. 제때에 탈지 탱크에 탈지제를 추가하거나 탈지 효과를 보장하기 위해 탈지 탱크의 용액을 교체하는 데 주의하십시오.
